Products & technology - Chamber filter plates
Chamber filter plates
The recessed chamber filter plate made from polypropylene is a development of the plate and frame filter plate and has the same functionality.
The chamber plate frame is however integrated within the chamber filter plate thus significantly enhancing the plate's stability. This enables chamber filter plates to be used at much higher filtration pressure levels. Optional cake and plate thicknesses are available depending on the specific filtration conditions and application. Klinkau chamber filter plates can also be supplied in caulked and gasketed design (CGR). The chamber filter plates are made of plastic and feature excellent chemical resistance and simple handling.
Advantages of chamber filter plates
- Single element and therefore cheaper than separate plates and frames
- Filtration pressures of up to 50 bar
- Suitable for high filtration temperatures
- Robust design with reinforced edges
- The recessed filter has a special pipped surface to protect the filter cloth and ensure excellent filtration
Chamber filter plate HR Design
The design and manufacturing method for the HR gives a low-cost alternative to standard chamber filter plates. It is available in sizes 470mm, 500mm, 630mm, 800mm and 1000mm, and up to a maximum filter cake thickness size of 32mm.
|Standard sizes: 250, 400, 470, 500, 630, 800, 915, 1000, 1067, 1200, 1300, 1450, 1470, 1500, 1500 x 2000 und 2000 x 2000 mm. These formats are available in open and closed designs. Larger and alternative formats available upon request.
|Feed eye position
|Standard feeds: Centralised feed, decentralised feed, corner feed, external feed, position eye In general, any feed eye design is possible and can be made according to customer requirements.
|Standard products are suitable for a maximum filtration pressure of 8 or 16 bar depending on the product. Special products for pressure levels of 30 bar and higher are available.
|Maximum permissible filtration temperatures depend, among other things, on filtration pressures, chemical composition of the slurry to be filtered, cycle times and choice of material.
|Klinkau chamber filter plates are available in the following materials according to intended use:
|Polypropylene homopolymers / copolymers
|Polypropylene homopolymers FDA / copolymers FDA
|Other materials available on request
In a conventional chamber filter press, filter cake is formed in layers until the chamber is full with solid matter. As the filter cake forms, its permeability and flow rate decrease as the solid content increases within the chamber and the cake becomes increasingly drier.
Compressible products reduce cake permeability to a disproportionate degree, which can lead to longer filtration cycles and thus higher operating costs. Inefficient filtration cycle times can be avoided by using membrane filter plates.